Fork lift power units

Home
Fork lift power units

Recommended

90/105-50-180-480
1. The cylinder of this hydraulic cylinder is a 90 / 105 inner wall rolling pipe, number 20 carbon steel.
2. The piston rod is 45mm diameter, 50carbon steel, chrome surface.
3. Install 40 * 50 steel sleeve for earrings and cylinder bottom.
4. The cylinder surface with black paint.
75/90-42-235-632
1. The cylinder of this hydraulic cylinder is a 75 / 90 inner wall grinding tube, number 20 carbon steel.
2. The piston rod is 42mm diameter, 45 gauge carbon steel, chrome plated surface.
3. The cylinder surface is gray paintoil tank surface blue paint.
Set of 50/60-45-290 471
1. The cylinder of this hydraulic cylinder is a 50 / 60 inner wall rolling tube,20 carbon steel.
2. The piston rod is 45mm diameter, 45 carbon steel, chrome surface.
3. The earrings and cylinder bottom are pin-hole 22mm universal bearings.
4. Oil mouth is G 3/8, oil tank surface blue paint.
1.5 ton turbocharged cylinder 80/95-40/60-35-124
1. The cylinder of this hydraulic cylinder is an 80 / 95 inner wall grinding pipe, number 20 carbon steel.
2. The piston rod is 40mm diameter, 45 carbon steel, chrome surface.
3. The oil mouth is G3 / 8, the oil cylinder surface gray baking paint.

Fork lift power units

Read More About Automotive power unit

This power unit is designed exclusively for the fork multi-functional manifold, vavles,tank, ect. The upand down movements are controlled by the level of the mannal release valve, whichis equipped with an electric switch for the motor start. The lowering speed isautomatically adjusted by the pressure compensated flow control valve.

Send Email to Us Download As PDF

Product Detail

Product Tags

Model specifications

Motor voltage	power of motor	Displacement ml/r	Overflow valve pressure/Mpa	tankage	L（mm）
12V	1.5KW	1.2	20	3.5	411
		1.6		5.0	461
		2.1		5.0	461
24V	2.2KW	2.1	20	6.0	511
		2.5		8.0	581
		2.7		8.0	581

Matters needing attention

1.The duty of this power unit is S3, i.e., 30 seconds on and 270seconds off.
2.Clean all the hydraulic parts concerned before mounting the power unit.

3.Viscosity of the hydraulic oil shoud be 15-68 cst,which should also be clean andfree of impurities. N46 hydraulic oil is recommended.

4.Change the oil after the first 100 hours of running the power unit, then changethe oil every 3000 hours.

5.The power unit should be mounted horizontally.

If you are interested in our products, you can choose to leave your information here, and we will be in touch with you shortly.

Write your message here and send it to us

Products categories

If you are interested in our products, you can choose to leave your information here, and we will be in touch with you shortly.

English